Flexispot Standing Desk Evaluation …Used Flexispot Desk…
Cons: What I Didn’t Like About the Flexispot E7
Though the cons on this desk are minimal, here are a couple of features that I wasn’t always a substantial fan of:
The plan that the desk can be found in was heavy, so bringing it inside was a group effort, however this is simply a repercussion of how sturdy the Flexispot is.
The convenient cable television tray was a little bit confusing to set up. In the end, you ultimately slip it under screws, which wasn’t really clear from the directions.
You will need to buy an anti-fatigue mat to remain comfy, but this is an excellent concept for any standing desks, so I can’t fault Flexispot for that.
When it showed up and I saw how heavy it was, I was both ecstatic (considering that this implied it was going to be strong) and likewise a little reluctant (due to the fact that we all know just how much of a difficulty putting together furniture can be).
Fortunately, with the help of an instructional YouTube link, it took me only around 42 minutes to assemble. Scratch that, it took my 11-year-old child, with some supervision from me, from start to finish. The only problem I have with assembly was the cable tray, which I found wasn’t explained well in the instructions.
When assembled, I like the sleek look of this desk. I’m positive any of the many diverse surfaces that it can be found in would look terrific in any workplace, and the adjustable width makes it simple to fit it in even the smallest of home offices.
The quiet operation and height memory settings make it easy, efficient, and quiet to switch between sitting and standing as often times as you want throughout the day.
Finally, this desk is sturdy. It can hold up to 335 pounds even while in operation, so if you have a large desktop computer (or wish to take a nap on it for some reason) it has you covered. It will also equally disperse weight no matter how out of balance the weight you put on it is, it won’t wobble or wiggle.
because video is pretty kitted out as the desk we’re taking a look at today is quite fundamental I attempted to get as near that as I could on uplifts site with equivalent setups the flexi spot desk we’re taking a look at today will run you about four hundred and ten dollars versus six hundred and fifty for a comparable desk from uplift I attempt to get as close as possible with the uplift model is actually five inches longer but you can do a lot with 5 inches boom yes now for openness flexi spot did send this desk out for evaluation but as you must know by now doesn’t affect my review in any way the desktop here is 55 inches large 28 inches deep and comes as a $40 upgrade from the base size of 48 by thirty sixty by thirty is coming but it’s not delivering up until the end of April at the earliest the desktop is an inch thick however it’s this standard laminate as you can perhaps get doing not have even any cable television grommets for go through the outdoors carton
for the desktop was not harmed in any way which is absolutely strange because I might shoot a 30-second b-roll montage of simply the damage and flaws on this desktop scuffed scraped pitted just extremely rough guy if I had actually purchased this I ‘d have been on the phone with customer service instantly they did likewise handled to miss drilling the pilot holes where you can attach the control box to the desktop a great deal of having to do that myself without accidentally drilling through the other side of the desktop so yeah pilot holes in wood screws is how you’re gon na be attaching the surface to the frame that’s a far cry from the embedded metal inserts that we saw on the uplift desk so assembly aside from needing to drill that top was actually quite straightforward the whole thing came together in about 45 minutes and despite the fact that there’s cables going to it from each component to support motorized function strangely absolutely where any kind of cable television management products whatsoever the frame on this unit is a single motor double stage design versus the double motor three-stage style that comes standard with the uplift desk this can be upgraded also to both the double stage double motor and a three-stage double motor which pushes the expense of the desk up
an extra 70 bucks the frame is developed for a max load of 154 pounds and it moves at a rate at an inch per 2nd the height can range from just under 28 inches to simply over forty 7 point six inches so a max I ‘d it is more than high sufficient even for me and I remain at 6 foot for this model does come standard with the control board that enables up-and-down motion plus three memory spots with an LED readout to tell you the desk height the single motor style utilizes this drive shaft assembly which needs to be adjusted as the width of the desk is changed the motor operation itself while it might be sluggish is really peaceful as in barely audible this outside a cost would be the one advantage I would provide this system over the uplift desk and I want to be careful here due to the fact that this isn’t a hit piece this desk is 240 dollars less expensive than the comparable uplift design over 35% less expensive even if you update this flexi area test to the dual motor three-stage style it still can be found in a hundred and seventy dollars more affordable than the uplift but more affordable does not indicate low-cost this desk is still over four hundred dollars if I had paid over $400 for this desk I ‘d have an issue with that the front to back stability of this desk is strong even if max height I’ll certainly give it that but the lateral stability of this desk the horizontal motion at this price point it’s inappropriate it’s add insult to injury here they consist of a little safety baffle this little steel piece that installs to the frame and covers a portion of this turning driveshaft when
this desk sees any lateral movement at all the drive shaft hits this baffle and the sound is absolutely frustrating to leading things off I decided to add rolling casters to this desk this was a $30 upgrade and 2 of those four casters showed up damaged too my prepare for this desk at this point is to lose the desk top and came with all together and replace it with a white laminate lemon table from Ikea and use it as an adjustable image table which you can’t do this frame will accommodate desktops as much as 63 inches broad and 31 and a half inches deep so this will roll around the studio make it easier to movie items without having to change complex or heavy slider setups and what I personally pay $400 for that no I lucked out that I discovered uplift first that is an investment in quality office furnishings that will last you this at best seems like a more affordable replica of that it just doesn’t feel quality and the difference between this desk and my primary desk is night and day do feel free to check out their site also which also feels eerily similar to among their rivals there’s a wealth of accessories you can get for the flexi spot desk approximately and including a foot massager and even a stationary exercise bike and I might spend another 10 minutes of our valuable time covering different options and accessories I might however I think I’m happier that they just sent out a standard desk since as a basic desk I’m not a fan of the quality assurance at this rate point and I do not think slapping on a lot of additionals is the move when the core item isn’t what it ought to be they do provide a 30-day trial if you’re just morbidly curious and they service warranty their desks for 3 years really desk is five years and uplift desk is 7 years if you are Used Flexispot Desk
in the market for a sit-stand desk they’re remarkable mine’s been a life changer for me both in regards to gaming and performance however I would spend the additional money it’s gon na require to get into a greater end producer like uplift desk or really desk and I have not personally utilized extremely desk products so I can’t speak on it however their credibility is excellent huge thanks to flexi spot for sending this out for evaluation sadly I can not suggest this unit and for the record I’m a hundred percent sure they would have happily changed the parts that I had a problem with viewing as how both the desktop and the casters showed up harmed however from a customer viewpoint you ‘d most likely be really delighted to get this in