Flexispot Standing Desk Review …Flexispot Vici 48W Quick-install Height-adjustable Desk Ec9B…
Cons: What I Didn’t Like About the Flexispot E7
Though the cons on this desk are minimal, here are a few features that I wasn’t always a substantial fan of:
The package that the desk can be found in was heavy, so bringing it inside was a group effort, but this is simply an effect of how strong the Flexispot is.
The hassle-free cable television tray was a bit confusing to install. In the end, you ultimately slip it under screws, which wasn’t very clear from the directions.
You will require to purchase an anti-fatigue mat to remain comfy, but this is a good idea for any standing desks, so I can’t fault Flexispot for that.
When it showed up and I saw how heavy it was, I was both thrilled (because this meant it was going to be tough) and likewise a little hesitant (because all of us understand just how much of a difficulty assembling furniture can be).
Luckily, with the help of a training YouTube link, it took me only around 42 minutes to put together. Scratch that, it took my 11-year-old daughter, with some guidance from me, from start to finish. The only hang-up I have with assembly was the cable tray, which I discovered wasn’t described well in the instructions.
Once assembled, I enjoy the sleek appearance of this desk. I’m positive any of the many diverse finishes that it is available in would look fantastic in any office, and the adjustable width makes it easy to fit it in even the smallest of home offices.
The quiet operation and height memory settings make it simple, efficient, and peaceful to change in between sitting and standing as lot of times as you want throughout the day.
This desk is strong. It can hold up to 335 lbs even while in operation, so if you have a large home computer (or wish to take a nap on it for some reason) it has you covered. It will also evenly distribute weight no matter how out of balance the weight you put on it is, it will not wobble or wiggle.
because video is pretty kitted out as the desk we’re looking at today is quite fundamental I tried to get as close to that as I might on uplifts site with equivalent configurations the flexi spot desk we’re taking a look at today will run you about four hundred and 10 dollars versus six hundred and fifty for a comparable desk from uplift I attempt to get as close as possible with the uplift model is in fact 5 inches longer however you can do a lot with 5 inches boom yes now for transparency flexi spot did send this desk out for review but as you should understand by now does not affect my evaluation in any way the desktop here is 55 inches large 28 inches deep and comes as a $40 upgrade from the base size of 48 by thirty sixty by thirty is coming but it’s not delivering up until completion of April at the earliest the desktop is an inch thick however it’s this basic laminate as you can potentially get doing not have even any cable television grommets for go through the outside container
for the desktop was not harmed in any way which is utterly strange due to the fact that I could shoot a 30-second b-roll montage of just the damage and defects on this desktop scuffed scraped pitted simply super rough male if I had purchased this I ‘d have been on the phone with customer service instantly they did also managed to miss out on drilling the pilot holes where you can attach the control box to the desktop a lot of having to do that myself without inadvertently drilling through the other side of the desktop so yeah pilot holes in wood screws is how you’re gon na be connecting the surface area to the frame that’s a far cry from the embedded metal inserts that we saw on the uplift desk so assembly aside from needing to drill that top was actually quite straightforward the whole thing came together in about 45 minutes and despite the fact that there’s cable televisions going to it from each part to support motorized function unusually absolutely where any kind of cable management materials whatsoever the frame on this unit is a single motor double phase style versus the dual motor three-stage style that comes standard with the uplift desk this can be upgraded as well to both the dual phase dual motor and a three-stage dual motor which pushes the cost of the desk up
an extra 70 dollars the frame is developed for a max load of 154 pounds and it moves at a rate at an inch per 2nd the height can vary from just under 28 inches to simply over forty seven point six inches so a max I ‘d it is more than high adequate even for me and I stay at 6 foot for this design does come basic with the control board that enables up-and-down movement plus 3 memory spots with an LED readout to inform you the desk height the single motor design utilizes this drive shaft assembly which has to be changed as the width of the desk is adjusted the motor operation itself while it might be slow is extremely quiet as in barely audible this outside a cost would be the one benefit I would offer this unit over the uplift desk and I want to take care here due to the fact that this isn’t a hit piece this desk is 240 dollars less expensive than the similar uplift design over 35% cheaper even if you upgrade this flexi area test to the double motor three-stage design it still can be found in a hundred and seventy dollars less expensive than the uplift but less expensive doesn’t mean low-cost this desk is still over four hundred dollars if I had paid over $400 for this desk I ‘d have an issue with that the front to back stability of this desk is strong even if max height I’ll definitely offer it that however the lateral stability of this desk the horizontal motion at this cost point it’s undesirable it’s rub salt in the wound here they consist of a little safety baffle this little steel piece that installs to the frame and covers a part of this rotating driveshaft when
this desk sees any lateral motion at all the drive shaft strikes the noise and this baffle is absolutely infuriating to leading things off I decided to add rolling casters to this desk this was a $30 upgrade and 2 of those 4 casters showed up damaged as well my plan for this desk at this point is to lose the desk top and included all together and change it with a white laminate lemon table from Ikea and utilize it as an adjustable picture table which you can’t do this frame will accommodate desktops as much as 63 inches wide and 31 and a half inches deep so this will roll around the studio make it easier to movie items without having to change complex or heavy slider setups and what I personally pay $400 for that no I lucked out that I found uplift first that is an investment in quality workplace furnishings that will last you this at finest seems like a cheaper imitation of that it simply does not feel quality and the difference in between this desk and my main desk is night and day do do not hesitate to check out their site too which likewise feels eerily similar to among their competitors there’s a wealth of accessories you can get for the flexi area desk up to and including a foot massager and even a stationary exercise bike and I could spend another 10 minutes of our precious time covering different options and accessories I might but I think I’m happier that they only sent a standard desk because as a standard desk I’m not a fan of the quality control at this rate point and I don’t believe slapping on a lot of extras is the move when the core product isn’t what it ought to be they do use a 30-day trial if you’re simply morbidly curious and they service warranty their desks for three years very desk is five years and uplift desk is 7 years if you are Flexispot Vici 48W Quick-install Height-adjustable Desk Ec9B
in the market for a sit-stand desk they’re remarkable mine’s been a life changer for me both in terms of video gaming and efficiency however I would invest the money it’s gon na require to enter into a greater end maker like uplift desk or really desk and I haven’t personally utilized really desk items so I can’t speak on it however their track record is very good huge thanks to flexi area for sending this out for evaluation sadly I can not suggest this system and for the record I’m a hundred percent sure they would have gladly replaced the parts that I had an issue with viewing as how both the desktop and the casters showed up damaged however from a customer viewpoint you ‘d probably be actually delighted to get this in