Flexispot Standing Desk Review …Flexispot F8L…
Cons: What I Didn’t Like About the Flexispot E7
The cons on this desk are minimal, here are a few functions that I wasn’t always a big fan of:
The bundle that the desk can be found in was heavy, so bringing it inside was a group effort, but this is just a consequence of how tough the Flexispot is.
The hassle-free cable television tray was a little bit confusing to set up. In the end, you ultimately slip it under screws, which wasn’t extremely clear from the instructions.
You will require to purchase an anti-fatigue mat to stay comfy, but this is a good concept for any standing desks, so I can’t fault Flexispot for that.
When it showed up and I saw how heavy it was, I was both fired up (since this implied it was going to be sturdy) and also a little reluctant (since all of us understand just how much of an obstacle assembling furniture can be).
Fortunately, with the help of a training YouTube link, it took me just around 42 minutes to assemble. Scratch that, it took my 11-year-old child, with some supervision from me, from start to finish. The only problem I have with assembly was the cable tray, which I discovered wasn’t described well in the instructions.
When assembled, I love the smooth look of this desk. I’m positive any of the many varied finishes that it can be found in would look terrific in any office, and the adjustable width makes it easy to fit it in even the tiniest of office.
The quiet operation and height memory settings make it simple, effective, and quiet to switch between sitting and standing as often times as you want throughout the day.
This desk is strong. It can hold up to 335 lbs even while in operation, so if you have a substantial desktop computer (or wish to rest on it for some reason) it has you covered. It will also evenly disperse weight no matter how out of balance the weight you put on it is, it will not wiggle or wobble.
in that video is quite kitted out as the desk we’re taking a look at today is pretty standard I attempted to get as close to that as I might on uplifts site with similar configurations the flexi spot desk we’re taking a look at today will run you about four hundred and 10 dollars versus six hundred and fifty for a similar desk from uplift I try to get as close as possible with the uplift design is in fact five inches longer however you can do a lot with 5 inches boom yes now for openness flexi spot did send this desk out for review but as you should know by now doesn’t impact my evaluation in any way the desktop here is 55 inches broad 28 inches deep and comes as a $40 upgrade from the base size of 48 by thirty sixty by thirty is coming however it’s not delivering up until the end of April at the earliest the desktop is an inch thick but it’s this standard laminate as you can possibly get lacking even any cable grommets for travel through the outside container
for the desktop was not harmed in any way which is absolutely unusual due to the fact that I might shoot a 30-second b-roll montage of simply the damage and flaws on this desktop scuffed scraped pitted simply super rough guy if I had actually acquired this I ‘d have been on the phone with customer support immediately they did likewise managed to miss drilling the pilot holes where you can attach the control box to the desktop a lot of having to do that myself without mistakenly drilling through the opposite of the desktop so yeah pilot holes in wood screws is how you’re gon na be connecting the surface to the frame that’s a far cry from the ingrained metal inserts that we saw on the uplift desk so assembly aside from having to drill that top was really quite straightforward the entire thing came together in about 45 minutes and despite the fact that there’s cables going to it from each element to support motorized function oddly absolutely where any type of cable television management materials whatsoever the frame on this system is a single motor double stage style versus the double motor three-stage style that comes requirement with the uplift desk this can be upgraded as well to both the double phase dual motor and a three-stage double motor which pushes the cost of the desk up
an extra 70 dollars the frame is created for a max load of 154 pounds and it moves at a rate at an inch per second the height can vary from just under 28 inches to just over forty 7 point 6 inches so a max I ‘d it is more than high enough even for me and I stay at 6 foot for this model does come standard with the control panel that allows for up-and-down motion plus three memory areas with an LED readout to tell you the desk height the single motor design utilizes this drive shaft assembly which needs to be changed as the width of the desk is adjusted the motor operation itself while it might be slow is very quiet as in barely audible this outside a cost would be the one advantage I would give this unit over the uplift desk and I wish to take care here due to the fact that this isn’t a hit piece this desk is 240 dollars cheaper than the similar uplift model over 35% more affordable even if you update this flexi area test to the dual motor three-stage style it still can be found in a hundred and seventy dollars more affordable than the uplift but more affordable doesn’t indicate inexpensive this desk is still over four hundred dollars if I had paid over $400 for this desk I ‘d have an issue with that the front to back stability of this desk is solid even if max height I’ll definitely offer it that but the lateral stability of this desk the horizontal motion at this cost point it’s unacceptable it’s add fuel to the fire here they include a little safety baffle this little steel piece that installs to the frame and covers a portion of this turning driveshaft when
this desk sees any lateral motion at all the drive shaft strikes this baffle and the sound is definitely shocking to top things off I chose to include rolling casters to this desk this was a $30 upgrade and two of those 4 casters got here damaged too my prepare for this desk at this point is to lose the desk top and featured completely and replace it with a white laminate lemon table from Ikea and utilize it as an adjustable photo table which you can’t do this frame will accommodate desktops up to 63 inches wide and 31 and a half inches deep so this will roll around the studio make it much easier to movie products without having to adjust complex or heavy slider setups and what I personally pay $400 for that no I lucked out that I found uplift first that is an investment in quality workplace furniture that will last you this at best feels like a cheaper replica of that it simply does not feel quality and the difference between this desk and my main desk is night and day do feel free to take a look at their website as well which likewise feels strangely similar to one of their rivals there’s a wealth of devices you can get for the flexi area desk as much as and including a foot massager and even a fixed exercise bike and I could invest another 10 minutes of our valuable time covering numerous options and accessories I might however I believe I’m happier that they just sent out a standard desk due to the fact that as a basic desk I’m not a fan of the quality assurance at this rate point and I don’t think slapping on a lot of bonus is the relocation when the core product isn’t what it need to be they do provide a 30-day trial if you’re just morbidly curious and they warranty their desks for three years extremely desk is five years and uplift desk is 7 years if you are Flexispot F8L
in the market for a sit-stand desk they’re fantastic mine’s been a life changer for me both in regards to gaming and productivity however I would invest the additional money it’s gon na require to enter a greater end producer like uplift desk or really desk and I haven’t personally used extremely desk products so I can’t speak on it but their reputation is very good big thanks to flexi spot for sending this out for evaluation unfortunately I can not suggest this system and for the record I’m a hundred percent sure they would have happily changed the parts that I had a concern with seeing as how both the desktop and the casters showed up damaged however from a consumer perspective you ‘d probably be truly excited to get this in